Century Helicopter Products Swift Manuel d'instructions télécharger pdf (Page 20)

(1) Dry t the pinion gear to the main motor prior to mounting.

Make sure the main motor gear rides in line with the main gear on

the Swift.The key to installing the motor is the gear mesh. The elon-

gated slots for mounting the motor allow space to adjust the mesh

between the motor pinion gear and the main gear. Install the motor

to the motor mounting plate and secure with hardware provided by

the manufacturer of the motor.

(2) Install the batteries and control system neatly onto the electron-

ics tray. When installing electronics make sure that wires are not

going to come into contact with moving parts. Use foam rubber

wrap to wrap the receiver. ** The actual arranged components may

be different than the picture illustrates.

Motor

Mounting

Slots

Electric Motor

M3X12 Socket

Head Cap

Screws (2)

1) When setting up the pitch of the tail blades, the tail pitch plate should be rst set in the middle position of the tail rotor

shaft. The tail blades should have no pitch in that position. Tighten the tail rotor blades until the blade grips hold rm yet soft

enough so that the tail blades can still fold back in the event of a blade strike.

2) Adjust the position of the rudder servo bracket so that the tail pitch plate is centered on the tail rotor shaft while the servo

arm is at a 90 degree angle.

Tail rotor blades with zero pitch

(blade tips will be in-line)

Tail blades will line up in a at straight line

Hint: Setting zero pitch for tail blades

Recevier

Battery Pack

HINT: Installing industrial strength velcro will

help secure the batteries during aerobatics.

NOTE: The motor can be bolted

through the carbon battery tray

using the open spaces in the tray

and Main Gear

Mounting Motor and Electronics

Setting Tail Rudder Pushrod & Blades

8. Installing and Adjusting Control Components

As the rudder stick is moved

to the right, the rudder push-

rod will move forward increas-

ing the thrust in the tail blades

rotating the nose to the right.

MODE 1

MODE

(L) (R) (L) (R)

Receiver

ESC

**You must install the correct

pinion to motor shaft before

installing the motor.**

For details on Motors and Pinions

See page 27.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 30 31

Commentaires sur ces manuels

Pas de commentaire

Century Helicopter Products Swift Manuel d'instructions Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Jouets et accessoires Century Helicopter Products Swift