Century Helicopter Products Raven 50 V2 Spécifications télécharger pdf (Page 21)

35mm

From parts bag 6, assemble the landing gear by attaching the Aluminum Skids through the Struts, securing

them with four 3x5mm Set Screws. Set the distance from the rear of the skid to the strut at 35mm. Attach the

landing gear to the main mechanics using four 3x16mm(30) or 3x20mm(50) Machine Screws inserted from

the bottom of the struts and through the M3x9 plastic spacers into the lower side frames and secure with four

M3 locknuts.

Plastic Struts - 30

[HI3122] x 2

M3x5SS Set

Screws x 4

(small hex key)

Aluminum Skids - 30

[HW3123] x 2

M3x16/20

Machine

Screws x 4

From parts bag 7, notice that the

Tail Rotor Drive Shaft has 2 holes,

one through the shaft

and one drilled partially

into the shaft. Slide the

small Bevel Gear with the teeth

facing the shaft from the end with

the through hole and position the

gear aligning the holes. Press the

2x12mm Pin through and secure

with one 3x4mm Set Screw (Tip 1)

using threadlock. Slide the Spacer

Tube onto the shaft and position

against the gear.

2x12mm Pin

Tail Rotor Drive

Shaft [HW3073]

Bevel Gear A

[HI3075]

M3x4SS Set

Screw

(small hex key)

Spacer Tube

[HW3074]

Antenna Plastic

Guide Tube

Hole through

shaft

Step 26 Landing Gear Assembly

Step 27 Tail Output Shaft Assembly

M3x9x4 Plastic

Spacers x 4

When routing the

antenna wire from

your receiver, insert the

wire through the plastic

guide tube and attach to

the vertical fin using an

elastic tied between the

end of the antenna wire

and the fin.

Plastic Struts -50

[HI3122A] x 2

Aluminum Skids - 50

[HW3123A] x 2

Tail Rotor

Blades [HI3099]

x 2

M3x20 Socket

Cap Screw

M3 Lock-

nut

After flying the model, if a vibration is noticed on the horizontal fin, you can remove the

complete tail rotor assembly with the hub and further balance it using a High Point balancer.

Careful sanding of the rotor blades is all that is needed.

Leading Edge

Snap the ball on the tail rotor

grip into the adjoining pitch

slider link on both sides.

Install the Tail Rotor Blades

shimmed with 3x10mm plastic

washers on both sides using

two 3x20mm Socket Cap

Screws and M3 locknuts.

Note the direction of the

blades on the diagram, the

straight leading edge of the

blade should be on the same

side as the ball on the blade

grip. To tension the blade

bolt, start loose and tighten

until the blade holds horizon-

tal but pivots freely when

shaken.

Step 32 Tail Blades Assembly

M3x10x1.5

Plastic Washer x

CN2243

Tuff Landing Gear

1 2 ... 16 17 18 19 20 21 22

Commentaires sur ces manuels

Pas de commentaire

Century Helicopter Products Raven 50 V2 Spécifications Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Jouets et accessoires Century Helicopter Products Raven 50 V2